How to Use Apply nail polish on your nails and wait until completely dry. We recommend using fast dry top coat over nail polish or bare nails to create a flat surface which helps the product stick better. Make sure nail is dry and free of oily residues before applying product. Lightly push tape/stencils to the nail using a finger, especially paying attention to the areas near skin, cuticles, and the tips of long nails. You can always cut nail tape to size if they are too long and cut stencils to help them form better to the tip, sides and curvature of the nail. Try peeling stencils from different directions if you have trouble with smaller pieces not remaining on the backing paper. Find your direction and peel fast, holding stencil close the backing sheet. When small pieces remain within a stencil, flip and stick/peel the stencil to the back of the paper to remove all stuck pieces. Apply fresh or thinned, not thick or gloopy, nail polish across the tape/stencil. Shimmer and metallic nail polishes work better than cremes. We recommend applying nail polish with a sponge lightly pushing it to your nail, similar to ombre design, this prevents any polish bleeding under the stencil ... [Read More]

How to Use Remove your new stamping plate from its packaging and remove the plastic protective film from over the metal. When you first receive your plate and after every use wipe clean your plate with acetone or non-acetone nail polish remover without oils. Quickly apply a thick layer of nail polish in a few strokes over the design you wish to stamp. Special stamping polishes are recommended but opaque nail polishes that do not dry very fast also work well. Try another polish if you are not getting results you want. Hold a plastic card firmly at a 45 degree angle and lightly scrape across the plate to remove excess polish. Try to only scrape once, do not push card to plate too hard and work as quickly as possible to avoid drying. Immediately after scraping, quickly transfer the design to your stamper by firmly rolling once across the design from one side to the other or pushing once straight into the design. If your image does not transfer you may need to work faster, scrape differently (less pressure or new angle), prime your stamper (with acetone or gentle nail file/buffer) or try another opaque nail polish that doesn't dry very fast. Quickly transfer the image from t... [Read More]

25pcs Halloween Party Glow in the Dark Witch Red Claw Tips Finger NailsDescription:100% brand new and high qualityMaterial:PlasticTop Finger Length: Approx.7.3 cm/2.9 inchFinger Nail Length:Approx.1.7 cm/ 0.7 inchPerfect for halloween party, prank joke toy

ColorGlow In The Dark GreenElvira Press On Nails

these are the 2013 halloween collection, very limited time! buy all 6 designs. candy corn, gobblins, trick or treat, black