Description : Disc: 1.5cm. Output Voltage: 24V DC. With a US AC/DC adapter. Input: 110-250V, 50/60Hz Output: DC 24V, 700mA Cable Length: 210 cm (82 inch) (90cm attach to adapter, 120cm attach to mist maker), 3.5mm in diameter Package included : 1 x Mist maker 1 x AC-DC adapter (US plug) Points for attention: 1. Do not turn over the Mist Maker When the switch is turned on,keep upright,or it may damage the atomizer. 2.Please ensure that the daily running time is less than 10 hours, otherwise the life of atomizing slice will be shorted. 3. Don't touch the atomizing slice while the Mist Maker is working. 4. Ensure the water at high quality, use clean tap water.(water quality deterioration may influence the lifetime) 5. Please switch off the power before Movement or maintenance. 6. The atomizing slice is consumable,and its service life is¡Ý3000 hours.If marked reduction of Mist present, please clean atomizing slice with a cotton swab(don't need to use any detergent).Keep it clean. Note: The product of the nozzles upper part, the water injection mouth more than 2-3 cm best, not less than nozzles, also cannot too higher than nozzles

Specification: Material: ABS plastic Aerosolized amount:≥300mL/H 12 changing LED light. Input: 110-240V, 50/60Hz(With a US AC/DC adapter) Output: DC 24V, 700mA Disc: 1.8inch. Mist Maker Size: 1.8inch diameter, 1.8inch tall Cable Length: 210 cm (82 inch) (90cm attach to adapter, 120cm attach to mist maker) , 3.5mm in diameter How to Use: 1. DO NOT touch the atomizing slice while the Mist Maker is working. 2. Please SWITCH OFF the power before any movement or maintenance. 3. Keep the nozzle 2-3CM under the water level to get the best atomization effect. 4. Ensure the water is in high quality, use clean tap water.(not work for the distilled water) 5. The atomizing slice is consumable, and its service life is≥3000 hours. If the mist decreases, please clean the atomizing slice with a cotton swab(no need to use any detergent).Always keep it clean. Package included : 1 x Mist maker 1X removable splash guard 1 x AC-DC adapter (US plug)

Mist maker instructions For initial use,be sure the input voltage marked on the transformer must be same as your local power supply. If not, please do not use it until get a correct transformer from your local distributor. Place the MIST MAKER into a water container placidly, and pour into enough clean water.If the water is not enough to submerge the water-lever sensor switch, it can not generate mist;But if the water depth is too high,the mist is small or even no mist generated. Please refer to the following drawing No.2 for the best water lever. The MIST MAKER shall generate calori when it is working,the water temperature shall be rising,recommend to use it in a big volume or a good radiating water container. Place the transformer in a drafty place,and far away moist place. Connect the MIST MAKER with the transformer properly. Plug the transformer into power supply and electrify,if it is correctly installed, it will start to work immediately. PARAMETER Limited temperature:5~40 C Water rate:>350mL/H Depth of water limited :45~65mm Rate voltage :15W Products include: 1*mist maker 1*Waterproof frame 1*power Click on the shopping cart to make a purchase, make your Halloween differen... [Read More]

This AGPTEK mist maker can add a stunning mist effect to your pond or water tank to filter the bad smell with electro and ultrasonic technology. You can put it in your pond, rockery, fish tank, vase, birdbath, etc. than it will create a magical atmosphere. Disc: 1.5cm. Output Voltage: 24V DC. With a US AC/DC adapter. Input: 110-250V, 50/60Hz. Output: DC 24V, 700mA. Aerosolized amount:=400mL/H Cable Length: 210 cm (82 inch) (90cm attach to adapter, 120cm attach to mist maker), 3.5mm in diameter Package included : 1 x Mist maker 1 x AC-DC adapter (US plug) Points for attention: 1. Do not turn over the Mist Maker When the switch is turned on, keep upright, or it may damage the atomizer. 2. Please ensure that the daily running time is less than 10 hours, otherwise the life of atomizing slice will be shorted. 3. Don't touch the atomizing slice while the Mist Maker is working. 4. Ensure the water at high quality, use clean tap water.(water quality deterioration may influence the lifetime) 5. Please switch off the power before Movement or maintenance. 6. The atomizing slice is consumable, and its service life is=3000 hours. If marked reduction of Mist present, please clean atomizing s... [Read More]

This 12 LED mist maker can add a stunning mist effect to your pond or water tank to filter the bad smell with electro and ultrasonic technology.You can put it in your pond, rockery,fishtank,vase, birdbath, etc.than it will create a magical atmosphere. Points for attention: 1. Do not turn over the Mist Maker When the switch is turned on,keep upright,or it may damage the atomizer. 2.Please ensure that the daily running time is less than 10 hours, otherwise the life of atomizing slice will be shorted. 3. Don't touch the atomizing slice while the Mist Maker is working. 4. Ensure the water at high quality, use clean tap water.(water quality deterioration may influence the lifetime) 5. Please switch off the power before Movement or maintenance. 6. The atomizing slice is consumable,and its service life is=3000 hours.If marked reduction of Mist present, please clean atomizing slice with a cotton swab(don't need to use any detergent).Keep it clean. Package included: 1 x Mist maker 1 x AC-DC adapter (US plug) Note: The product of the nozzles upper part, the water injection mouth more than 2-3 cm best, not less than nozzles, also cannot too higher than nozzles Please do not use pure wate... [Read More]

Specifications: 1. Mist Maker Size: 4.6 cm diameter, 4.2cm tall 2. Material:aluminum 3. Aerosolized amount:?400mL/H 4. Disc: 1.5cm. 5. Output Voltage: 24V DC. 6. With a US AC/DC adapter 7. Input: 110-250V, 50/60Hz 8. Output: DC 24V, 700mA 9. Cable Length: 210 cm (82 inch) (90cm attach to adapter, 120cm attach to mist maker) , 3.5mm in diameter Points for attention: 1. Do not turn over the Mist Maker When the switch is turned on,keep upright,or it may damage the atomizer. 2. Please ensure that the daily running time is less than 10 hours, otherwise the life of atomizing slice will be shorted. 3. Don't feel with the hand the atomizing slice while the Mist Maker is working. 4. Ensure the water at high quality, use clean tap water.(water quality deterioration may influence the lifetime) 5. Please switch off the power before Movement or maintenance. 6. The atomizing slice is consumable,and its service life is ?3000 hours.If marked reduction of Mist present, please clean atomizing slice with a cotton swab(don't need to use any detergent).Keep it clean. Note: The product of the nozzles upper part, the water injection mouth more than 2-3 cm best, not less than nozzles, a... [Read More]

450W Heater Output: 1500 CFM ,1 Pint Tank Capacity Free Pint Of Fog Includes Wired Remote (Fc-1) Manual Fog Button Dim: 9.5"H X 5.5"W X 4.3"D Power 110V

Updated Version: Power indicator: blue, turn off after 5 seconds. Warning of water shortage: when no water is detected(below the probe detection position) during spray or when the spray key is pressed, the blue light will turn off after flashing for 3 seconds.Touching light: Short press the light switch key, turn on the LED light, white light on; press again and turn off the light; Touch function is invalid in "off" state; In the "on" state, touch the second half of the mushroom head shell will change the color(one color for each touch) white-red-yellow-green-light blue-blue-gradual-change mode-off, cycle.CautionsDo not touch the fog hole with your hands or hard objects, to avoid the atomized film blocked.When the water is filled, do not hold the top of the humidifier, to avoid the bottom fall off and the desktop get wet.When the water is fully filled, the humidifier can't be sprayed, adding to MAX water line is the best, please avoid adding hot water.The cotton core needs to absorb moisture fully and the humidifier can work, otherwise it is easy to damage the atomizer; First time use or long-term non-use, please wait for 5-10 minutes after adding water, until the cotton core absor... [Read More]

Halloween Fog Machine: Make fog to create a spooky and mysterious atmosphere. Control from 15 meters away! Remote Control & Manual: A red light will show when the fog machine has preheated successfully. Press the button on the console directly or press the remote control button to emit fog. The remote has a lobster clip, so you can lock it to the key chain and never worry about loss. One Key On and Off: On the back of the machine, there is one 'on' and 'off' key for easy starting. Fuse Protection: Once over load, the fuse protection will kick in and the machine will stop. Features: Output: 2000CFM First time use warm up: 5 minutes Regular use warm up: 2-3 minutes Output distances: 2-3 M Remote Control: 15 M Package Contents: 1 x Fog Machine kit 1 x Remote Console & Manual Control 1 x Remote Handle 1 x User Manual Warm Note: 1.Always check whether there is enough fog fluid in the tank before each use to avoid danger. 2.Do not spray fog to people directly and keep it far away from fire or other heat resources.

This AGPTEK mist maker can add a stunning mist effect to your pond ,rockery or water tank to filter the bad smell with electro and ultrasonic technology. You can put it in your pond, rockery, fish tank, vase, birdbath, etc. Then it will create a magical atmosphere. Mist Maker Size: 3.5 cm diameter, 4cm tall. Disc: 1.6cm. Output Voltage: 24V DC. With a US AC/DC adapter. Input: 110-250V, 50/60Hz Output: DC 24V, 700mA Points for attention: 1. Do not turn over the Mist Maker When the switch is turned on, keep upright, or it may damage the atomizer. 2. Please ensure that the daily running time is less than 10 hours, otherwise the life of atomizing slice will be shorted. 3. Don't touch the atomizing slice while the Mist Maker is working. 4. Ensure the water at high quality, use clean tap water. (Water quality deterioration may influence the lifetime) 5. Please switch off the power before Movement or maintenance. 6. The atomizing slice is consumable, and its service life is=3000 hours. If marked reduction of Mist present, please clean atomizing slice with a cotton swab (don't need to use any detergent).Keep it clean. Note:The product of the nozzles upper part, the water injection mouth mo... [Read More]

WOWParts team offers 30 days return or replacement quality warranty & lifetime technical supports. Please contact us freely if you need anyfurhter assistance. Product Features: 100% brand new and high quality. No heat or chemicals used. With 12 LED: 4 red + 4 yellow +4 blue light, different color group LEDs lights up alternately. Easy to operate, put in the water and the voltage is 17V, then the mist appears. Long service life, self-protection. Ideal for indoor or outdoor fountains, water feature, and office use. Add a stunning mist effect to your pond or water tank to filter the bad

**Package Includes:**(1) Chauvet H700 Fog Machine(1) American DJ Black 24BLB UV BlacklightThis **Chauvet H700** fog machine is perfect for any party or event. It provides the quality, performance and innovation for which Chauvet is known. This Chauvet H700's generous capacity tank and quick heat up of water based fog can fill most venues within minutes. It features a 0.6 liter capacity, a 2.5 minute heat up time, and it includes a wired remote.Get a great deal on the **Chauvet H700** from VMInnovations! Also included, the American DJ Black 24BLB 2 Foot Black Light is made of durable and high quality

Features:The fog machine is made of quality material with fine craftsmanship, durable for long time use.Supports cable and remote controller, easy to operate.Adopts special tubing technology for lengthening durability and decreasing the failure of congestion.Make better quality fog via advanced constant temperature control system.More energy-saving than other normal products.Multiple colors to choose, offer beautiful illumination while making fog.  Specification:Material: MetalColor: BlackPower: 500WVoltage: AC 90-130V 50/60Hz; AC 220-240V 50/60HzCurrent Insurance: 230V/5A; 110V/10ALight Source: LED RGBWarm-up Time: 2-3minutesCapacity: 0.5LWorking Distance: 2-3metersFog Making Time: 20-30secondsFog Volume: 2000-4000cu.ft/minOperation: Remote controlSize: Approx. 24 x 12 x 13cm / 9.45 x 4.72 x 5.12inWeight: Approx. 1955g Package List:1 x